Push your theater to its limits with the V3601 home theater powered subwoofer. This powerful vented home theater subwoofer delivers clean dynamic output deep into the lowest frequencies. You will stop wondering if you bought enough subwoofer once you hear the V3601.
Create the very best home theater experience with a powered subwoofer from Power Sound Audio. Energize your room with fast, dynamic bass and cinema quality sound.
The V3601 subwoofer is powered by a 1700W RMS (4300W PEAK) built-in amplifier with ICEpower® audio technology. A DSP based feature board includes the essential controls to properly integrate the subwoofer into your system.
The MDF enclosure is heavily braced and assembled with rabbet joints for strong structural integrity. The enclosure is finished with a non-reflective and extremely durable textured material. An acoustically transparent fabric grille covers both front-firing 18 inch subwoofer drivers. A high flow slot port with an egde radius is located just below the bottom driver on the front baffle. The amplifier is mounted on the rear baffle.
The V3601 contains two 18 inch subwoofer drivers, which are capable of moving massive amounts of air. The 1.75 inch surround and poly cotton semi-progressive, high excursion spider allow the cone to move more than 2 inches peak to peak. The cast aluminum frame is mounted to the extremely linear and dynamic motor system, which provides the power to drive the cone in a symmetrical motion.
ICEpower® audio technology
Amplifier Power: 1700 watts
Inputs: Left and Right RCA inputs
On, Auto, Off selector
Gain control
Time delay(phase) control
Crossover control
Room size control
Custom DSP(digital signal processing) enables superior engineering refinement
CE and FCC approved; EMC and safety pre-approved
Fully integrated amplifier and power supply with mains-converter and auxiliary-converter
Patented HCOM modulation and control techniques for unparalleled audio accuracy
Sound optimized soft clipping
Soft start power up with mute/de-mute.
Thermal and over-current protection
Standby converter with low standby power consumption (less than 1 watt)
Three inch diameter, four layer copper voice coil wound on a rigid multi-layer aluminum former with Kapton heat shielding
Fatigue limiting designed, silver alloy lead wires
Single poly cotton semi-progressive, high excursion spider
Paper outer dust cap with acrylic coating
Mass loading cap that also strengthens the cone body
Under spider ventilation which aids power handling and improves power compression
Assembled in the USA
V3601 Frequency Response
The frequency response graph shows how the subwoofer will sound for a given input frequency or tone. Accurate reproduction of the source material is achieved with a flat frequency response as shown in the graph.
V3601 Compression
The compression graph indicates how the output of the subwoofer changes as the input signal increases.
16Hz - 25Hz:
125.2 dB
31Hz - 50Hz:
132.5 dB
63Hz - 100Hz:
135.3 dB
16Hz - 100Hz:
132.0 dB
V3601 Output
The V3601 output numbers are acquired by using the Consumer Technology Association (CTA)™ Standard, ANSI/CTA-2010-B - Standard Method of Measurement for Subwoofers, formerly known as CEA-2010.
Power Sound Audio Newsletter
Enter your email address to receive new product announcements, tips & tricks to optimize your system, and all other Power Sound Audio related news.